How to install a screw air compressor? Take a look at these! Most of the installation of the air compressor often does not pay much attention to, in fact, especially the air that carries the operation of the entire plant. Starting the whole body. It is not big, but once there is a small problem with the air pressure machine, it will affect the production of the entire plant.
The installation process of the screw air compressor is roughly divided into the following steps:
1. When the piping of the main road, the pipeline must have a slope of 1 ° ~ 2 ° to discharge the condensed water in the tube road. Secondly, the pressure of the pipeline must not exceed 5%of the set pressure.
2. The branch line tube must be connected from the top of the supervisor's road. To avoid the underwater flowing into the working machine in the supervisor road, the air exit pipeline of the air compressor should have one -way valve.
3. When installing the air pressure machine series, the ball valve or automatic drainage valve should be installed at the end of the main road, the Borz screw air compressor, the air compressor, the screw air compressor, and the Bowes air compressor to facilitate the condensation discharge.
4. The supervisor's road cannot be reduced arbitrarily. If you must be reduced or enlarged the screw air compressor pipeline, you must use a gradual tube, otherwise there will be a mixed flow at the joint, which will cause large pressure loss and affect the life of the pipeline.
5. It is recommended to use it: air compressor+separator+air storage tank+front filter+dryer+rear filter+fine filter.
6. Try to reduce the use of elbows and various valves as much as possible to reduce pressure loss.
